Telescopic system for a 2-panel sliding gate with a maximum passage width of 11 m, without wheels
| Product availability: | In stock | We normally dispatch goods within 24 hours. |
|---|
in stock
€383.73 including VAT
| Weight |
|---|
| 23 kg |
Description of Telescopic system for a 2-panel sliding gate with a maximum passage width of 11 m, without wheels
Kit for building a telescopic track-mounted sliding gate for a maximum passage width of 11m. The kit is supplied without rails, which must be purchased separately.
Set of galvanized steel components optimized for installing a two-leaf telescopic sliding gate. Additional telescopic kits can be purchased to enable telescopic operation of a multi-leaf gate. This system transfers force from one gate leaf to the other. The kit is ready to install in a right-hand configuration. For installation on the opposite side, follow the same instructions in the manual, but interpret them in reverse: install the mounting kits the other way around and prepare the gate leaves in the opposite manner.
The following are used for telescopic gates: the same operators as for standard sliding gates. The gate leaf farther from the operator will move twice as fast as the leaf closer to it.
TELESCOPIC GATE DIAGRAM:
MAINTENANCE AND CARE
After completing the installation and carrying out several manual test cycles, make sure that no parts are loose and that the gate does not catch anywhere. Regularly check that the moving parts are secure and that the telescopic system is properly lubricated.
If the gate is hit by a moving vehicle or due to another factor, check that no damage has been caused to the components that support and guide the gate.
If the gate starts to move with difficulty or vibrates during operation, check the guide rollers and other moving parts for wear and replace them if necessary. The service life of these components is significantly reduced in particularly damp, salty, acidic or dusty environments, or at temperatures above 120°C.
Pay particular attention to the motor and its speed on powered gates:
- high speed (at start-up or during deceleration) is detrimental to the system and can cause problems and malfunctions
- very low speed, on the other hand, leads to an “elastic effect” between the moving gate leaves
How can I order this item?
Choose the option that suits you:
- order online: use the buy button to add the goods to your shopping cart (you will find the buy button here in the product variants table).
- order by email: place your order at [email protected]
