Pairing remotes with the NICE Shel drive

Possible commands for operating the NICE Shel drive

You can control the Shel drive using four commands. Normally, only the first is used, but you can also pair another command with a remote control:

  1. Step-by-step operation with stop option - pressing the button on the remote repeatedly opens the gate, stops it, closes it, stops it, opens it again, and so on. This means you can use the same button to open and close the gate, and stop it while it is moving.
  2. Step-by-step operation without stop option - pressing the button on the remote repeatedly opens the gate, closes it, opens it, closes it, and so on. This means you can use the same button to open and close the gate, but it will not stop while moving; instead, it will continue in the opposite direction.
  3. Partial opening - when the gate is closed, pressing this button opens it slightly.
  4. Lighting control - there is a bulb in the drive that you can switch on and off.

Procedure for pairing a remote control with the NICE Shel drive

  1. You have 10 seconds for each step.
  2. Press the button on the control unit as many timesas the command you want to pair with the remote control; the green LED will then that many times as well.
  3. Press and hold the button on the remote control. When the LED on the drive flashes three longer flashes, release the button.
  4. Wait for the LED to finish flashing, and you’re done.

Pairing examples

Standard gate operation

You want to pair command number ONE, that is, step-by-step operation with stopping, meaning that repeatedly pressing the button will open, stop, close, stop, open, and so on.

  1. You have 10 seconds for each step.
  2. Press ONEtime without holding the P1 pairing button; the LED will then start flashing green ONEtime, pause ONEtime.
  3. Press and hold the button on the remote control. When the LED on the drive flashes three longer flashes, release the button.
  4. Wait for the LED to finish flashing, and you’re done.

Controlling the light in the drive

You want to pair command number FOUR, that is, lighting control, meaning that repeatedly pressing the button will switch the light in the drive on, off, on, off, and so on.

  1. You have 10 seconds for each step.
  2. Press FOURtimes in succession; the LED will then start flashing green FOURtimes, pause FOURtimes.
  3. Press and hold the button on the remote control. When the LED on the drive flashes three longer flashes, release the button.
  4. Wait for the LED to finish flashing, and you’re done.

Deleting a specific remote control button

  1. Press and hold the button on the control unit until the green LED lights first, then the red LED, and then both light up together. Keep holding the button. Keep holding the button.
  2. Keep holding the button on the control unit, then also press and hold the button on the remote control that you want to delete from memory.
  3. When the green LED flashes, release both buttons.

Deleting all remote controls

Note: This procedure is essentially a sub-step of clearing the NICE Shel memory.

  1. Press and hold the button on the control unit until the green LED lights first, then the red LED, and then both light up together; then release the button. The green LED will light first, then the red LED, and then both will light up together; then release the button.
  2. Press the button on the control unit 3 times in succession.
  3. After about 5 seconds, the red and green LEDs will flash rapidly to indicate that the deletion was successful.
Print page Print page