Clearing the memory of the NICE Shel drive

With the NICE Shel drive, three types of memory can be erased separately:

  1. Memory of programmed functions - deleting it restores the factory programming settings.
  2. Stored gate travel end positions - after deleting them, the gate movement must be assessed.
  3. Remote controls - all remote controls will be deleted from memory.
  4. You can also erase everything at once - all three of the above memory types will be erased at once.

Memory deletion procedure for the NICE Shel drive

  1. Press and hold the button on the control unit. The green LED will light first, then the red LED, and then both will light together. Release the button.
  2. Press the button on the control unit X times in succession, where X is the number of presses shown in the following table:
    Number of presses Memory to be erased
    1 Memory of programmed functions
    2 Stored gate travel end positions
    3 Remote controls
    4 Entire memory
    5 Cancel operation
  3. After approximately 5 seconds, the red and green LEDs will flash rapidly to indicate that the memory has been erased successfully.

Memory deletion examples

Complete memory erase (drive reset)

Note: This drive reset erases all memory, including remote controls.

  1. Press and hold the button on the control unit. The green LED will light first, then the red LED, and then both will light together. Release the button.
  2. Press the button on the control unit 4 times.
  3. After approximately 5 seconds, the red and green LEDs will flash rapidly to indicate that the memory has been erased successfully

Deleting all remote controls

The procedure is on a separate remote control pairing page.

 

Print page Print page