Wiring for NICE MCU1 control unit
The types of cables to use for each component in a drive system with a NICE MCU1 control unit are listed in the following “shopping” list:
Minimum required:
- Power supply – 3 × 1.5 mm2. If the power supply cable is longer than 30 m, use a larger cross-section, for example 3 x 2,5 mm2
Optional accessories:
- Photocells:
- TX transmitter: 2×0,5 mm2
- RX receiver: 2×0,5 mm2
- Flashing light:
- for the light: 2×1 mm2
- for the antenna: 50 Ohm shielded coaxial cable (RG58 type)
- Alternatively, use a two-core cable (2x0,5 mm2) if you want to open it with a standard switch, for example.
- Any other BlueBus accessories: 2×0,5 mm2. If the BlueBus cable is longer than 20m, use 2×1 mm2
