Setting up two Robus/Run motors in master and slave mode

Procedure for setting two sliding gates with opposing travel directions in motion using operators:

  • NICE Robus RB400, RB600, RB1000
  • NICE Run RUN1500, RUN1800, RUN2500
  • NICE Slight SLH400
  • NICE Naked Sliding NKSL400

Proceed as follows:

  1. Disconnect the operators from the power supply
  2. Connect the BlueBus terminals with a two-core cable (left hole to left hole, right to right; see wiring diagram) 
  3. If necessary, set the gate opening direction using the switch on the control unit
  4. Reconnect the power supply
  5. Set the slave unit mode on the slave unit (you have 10 seconds for each step):
    1. Press and hold STOP/SET. When L1 starts flashing, release the button.
    2. Press CLOSE seven times, until the flashing LED moves to position L8.
    3. Press STOP/SET once. LED L8 will change its flashing rate and then remain lit (or L1+L2 or L3+L4 may flash).
    4. Done.
  6. Detect the connected devices on the slave unit:
    1. Press and hold OPEN and STOP/SET. When L1+L2 start flashing rapidly together, release the buttons.
    2. After a short while, the LEDs will stop flashing. Done.
  7. Detect the connected devices on the master unit:
    1. Press and hold OPEN and STOP/SET. When L1+L2 start flashing rapidly together, release the buttons.
    2. After a short while, the LEDs will stop flashing. Done.
  8. Run the gate leaf movement learning procedure on the master unit:
    1. Press and hold STOP/SET and CLOSE. When L3+L4 start flashing rapidly together, release the buttons.
    2. The operators should open and close the gates. L3+L4 will then turn off, and the procedure is complete.
Print page Print page