Instructions for copying codes between ROGER remote controls
Procedure
- Stand within range of the receiver.
- On the new remote control, press and hold both buttons at the same time. The red LED will start flashing. Keep holding the buttons until the LED stays lit. Then release the button you do not want to copy the code to, and continue holding the button you want to copy the code to. At the same time, press the corresponding button on the original remote control. The red LED on the new remote control will light up briefly and then go out. The code has been copied successfully.
- If you cannot pair the remote controls directly with each other, save the new remote control to the receiver's memory as described in the drive instructions.
