How to get the NICE Spinbus operator with SNA2 control unit moving
The NICE Spinbus drive used to be supplied with a NICE SNA2 control unit. For this control unit, the setup procedure is as follows:
Setting up the NICE Spinbus drive with a NICE SNA2 control unit
- Plug the drive into a power outlet.
- With the factory settings (or after a reset), the BlueBUS LED and the L1+L2 LEDs on the control unit should be flashing.
- Evaluate the connected devices: Press and hold the OPEN+STOP/SET buttons simultaneously (the first and second buttons). When the L1+L2 LEDs start flashing faster (approx. When the L1+L2 LEDs start flashing faster (approx. 3–4 seconds), release the buttons. The L1+L2 LEDs will continue flashing for a short while, then stop, and L3+L4 will start flashing.
- Run the gate travel learning procedure: Press and hold the STOP/SET+CLOSE buttons together; when L3+L4 start flashing faster and the gate moves, release the buttons. When L3+L4 start flashing faster and the gate moves, release the buttons. The drive will close the gate, open it, and then close it again, leaving the gate closed.
- Learn the force required for opening: Pull and release the cord on the drive, which activates the small button on the control unit. The gate will open.
- Learn the force required for closing: Pull and release the cord on the drive, which activates the small button on the control unit. The gate will close.
- The gate should now open and close using the OPEN, STOP/SET, and CLOSE buttons. The OPEN button opens the gate, the CLOSE button closes it, and the STOP/SET button stops it.
- Congratulations—great job! You’ve set up your NICE Spinbus garage door drive!
